Hanson Rivet & Supply Co, Company

Hanson's Closed-End rivets prevent the passage of vapor or liquid through the set rivet. They also provide 100% mandrel retention. This means the head of the mandrel that breaks off stays in the set rivet. This assures that it won't fall into your assembly and rattle around or short...

Hanson's Easy Entry Rivets have a pointed end on the tip of the mandrel to help the operator locate the hole in the assembly and insert the rivet quickly.

Just insert the rivet, hit the pin. One man, working from one side of the job sets rivets easily and quickly in blind or open applications. Once you drive the pin, the job is done. Sheets are pulled tightly together, and you get a smooth finished head without secondary operations.

LENGTH (in 32nds) = WORK THICKNESS + CLINCH ALLOWANCE "F" (Example Part #: C1-9-ST for 1/8 x 9/32 - specify material and finish)

AVDEL MAXLOK®Lockbolt system is a two piece fastener consisting of a Lockbolt and Collar. The Lockbolt is placed through the work and the Collar is placed over the end of the Lockbolt. Using the proper tool the two are swagged together and the Lockbolt is broken off flush with the collar. This...

During installation the body collapses on the back side which grips the inside of the mounting surface. Fastens in blind holesVery thin flange or headKnurled body for anti-rotationWide grip range for metal and other materialsEasy installation with manual or pneumatic...

Capacity: 3/32" to 3/16" diameter Aluminum / Steel and 5/32" diameter All Steel standard open end blind rivets Weight: 3.75 lbs. - Pulling Force: 1,350 lbs. - Stroke .551" Standard Nose Pieces Included: 1/8", 5/32" & 3/16"

Hanson's Flush-Nutsare a versatile Threaded Insert that can be installed in any thickness of material over .030". Metal, plastic, fiberglass, or any rigid material will accept Flush-Nuts. During installation the base is drawn up into the upper sleeve swelling it in the work piece. After...

HANSON RIVETING HAMMERS are air powered and designed to set Solid and Tubular Rivets. With the proper Bit in the tool, the end of the bit is placed on the head for solid rivets or on the end of the shank for tubular rivets. A Bucking Bar or anvil is typically used to back up the other end of the...

are designed to clinch tubular rivets and the HT-100 can be used to set tubular and solid rivets using ourSQUEEZER DIES. These tools are operated by slight hammer blows to the top of the tool or they can be adapted to an arbor press or drill press.